foratvise
Loslegen
Anlagenausfall (Störungen)

Air compressor failure

Die wissenschaftlichen Inhalte dieser Seite werden auf Englisch und Spanisch veröffentlicht; hier werden sie auf Englisch angezeigt.

Kurz gefasst

Sie tritt bei etwa 1 von 100 untersuchten Linien auf.

Wenn sie auftritt, entfällt auf sie im Mittel etwa 57 % der Verlustzeit der Linie. Berichtet von 1 der 131 Studien, die sie beobachten konnten (spärliche Evidenz).

Was passiert

A mechanical, electrical or control fault in the compressed air generation unit (motor, valves, bearings, cooling system or control electronics) causes the compressor to trip or stop, interrupting the supply of compressed air to pneumatic actuators, valves and cylinders across the line. Filling and packaging equipment that depends on pneumatic actuation then loses the pressure needed to operate grippers, valves, pistons and seals.

Was man dagegen tut

Implement preventive maintenance on compressors (filter and oil changes, vibration and temperature monitoring, valve inspection) and install redundant compressors or a backup air receiver sized to ride through short outages. Add pressure monitoring with early-warning alarms and automatic switchover to a standby unit to avoid line-wide pneumatic starvation.

Praktische Hinweise auf Basis ingenieurtechnischen Wissens; keine statistische Schätzung.

1Wahrscheinlichkeit und Evidenz

Gepoolt über alle Segmente. Ein breites Intervall ist ein Ergebnis: Es zeigt, wie viel die Evidenz zu wissen erlaubt.
Auftretenswahrscheinlichkeit
0,6 % [0,1–1,6 %]
Erwarteter Anteil an der Verlustzeit
0,3 % [0,1–0,9 %]
Anteil an der Verlustzeit bei Auftreten
57 % [46–67 %]
Studien / Einheiten
131 / 165
Evidenzgrad
D

Grad D: 0 oder 1 Studie; die Schätzung beruht auf partiellem Pooling und Priori-Verteilungen, und das breite Intervall ist das Ergebnis.

2Wahrscheinlichkeit nach Segment

Partiell gepoolte Schätzungen für jedes Branchensegment.
  • Milchprodukte
    0,6 % [0,1–2,3 %]13 Studien
  • Erfrischungsgetränke, abgefülltes Wasser und Säfte
    0,6 % [0,1–2,0 %]26 Studien
  • Bier, Wein und Spirituosen
    0,9 % [0,1–3,4 %]12 Studien
  • Backwaren und Teigwaren
    0,6 % [0,1–2,1 %]25 Studien
  • Fleisch, Geflügel und Fisch
    0,7 % [0,1–2,5 %]9 Studien
  • Obst- und Gemüseverarbeitung
    0,7 % [0,1–2,4 %]7 Studien
  • Getreide- und Ölsaatenmüllerei
    0,7 % [0,1–2,5 %]7 Studien
  • Zucker und Süßwaren
    0,6 % [0,1–2,4 %]9 Studien
  • Snacks, Kaffee, Tee und sonstige Lebensmittel
    0,7 % [0,1–2,3 %]5 Studien
  • Futtermittel und Heimtiernahrung
    0,7 % [0,1–2,5 %]7 Studien
  • Lebensmittelherstellung (nicht spezifiziert oder gemischt)
    0,6 % [0,1–2,3 %]11 Studien

3Mechanismus, SCADA-Signatur und Gegenmaßnahme

Ingenieurpraktische Hinweise, um die Ursache zu erkennen und zu beheben; nicht Teil der statistischen Schätzung.

Mechanismus

Ingenieurpraktische Hinweise

A mechanical, electrical or control fault in the compressed air generation unit (motor, valves, bearings, cooling system or control electronics) causes the compressor to trip or stop, interrupting the supply of compressed air to pneumatic actuators, valves and cylinders across the line. Filling and packaging equipment that depends on pneumatic actuation then loses the pressure needed to operate grippers, valves, pistons and seals.

So zeigt sie sich in SCADA-Daten

Ingenieurpraktische Hinweise

Utility system logs show a drop in compressed air header pressure below setpoint coinciding with a compressor fault or trip alarm and a change in compressor run-state (running to fault/stopped). Downstream machines in filling, capping and packaging simultaneously register low-air alarms, actuator timeout faults or forced stops, with correlated downtime across multiple line assets fed from the same air header.

Gegenmaßnahme

Ingenieurpraktische Hinweise

Implement preventive maintenance on compressors (filter and oil changes, vibration and temperature monitoring, valve inspection) and install redundant compressors or a backup air receiver sized to ride through short outages. Add pressure monitoring with early-warning alarms and automatic switchover to a standby unit to avoid line-wide pneumatic starvation.

4Quellen

Jeder extrahierte Datenpunkt mit Studie, Wert und wörtlichem Zitat.
  1. Zeit zwischen Ereignissen: 41.444 not reported · laut Bericht: “Air Compressor”
    Wörtliches Zitat anzeigen
    Waktu Kerusakan Weibull MTTF 41444,25
  2. Mittlere Ereignisdauer: 338 not reported · laut Bericht: “Air Compressor”
    Wörtliches Zitat anzeigen
    Waktu Perbaikan Lognormal MTTR 337,5107
  3. Anteil an der Verlustzeit: 35,0 % · laut Bericht: “air compressor failures”
    Wörtliches Zitat anzeigen
    Loss and waste analysis conducted on the beer manufacturing process illustrated in Fig. 1 indicates that more than 35% of the total production downtime is attributed to air compressor failures.