Miscellaneous non-specific line stoppage
Die wissenschaftlichen Inhalte dieser Seite werden auf Englisch und Spanisch veröffentlicht; hier werden sie auf Englisch angezeigt.
Kurz gefasst
Sie tritt bei etwa 1 von 100 untersuchten Linien auf.
Wenn sie auftritt, entfällt auf sie im Mittel etwa 54 % der Verlustzeit der Linie. Berichtet von 4 der 127 Studien, die sie beobachten konnten (begrenzte Evidenz).
Was passiert
This bucket groups heterogeneous line stops that primary studies logged under generic or administrative labels rather than a defined technical failure mode, including development or trial runs, operator travel or walking time between stations, utility supply interruptions, generic equipment remarks, outright breakdowns, and incidental moisture loss. Because the original records do not isolate a single physical mechanism, the common thread is organizational or logistical rather than a specific component failure or process deviation.
Was man dagegen tut
Standardize the stop-reason taxonomy and operator training so that trials, travel time, utility outages, and equipment notes are logged under distinct, well-defined codes instead of free text, and route each resulting code to the appropriate loss category for root-cause analysis. Periodically review and reclassify residual generic entries to progressively shrink this catch-all bucket.
Praktische Hinweise auf Basis ingenieurtechnischen Wissens; keine statistische Schätzung.
1Wahrscheinlichkeit und Evidenz
- Auftretenswahrscheinlichkeit
- 1,3 % [0,4–2,9 %]
- Erwarteter Anteil an der Verlustzeit
- 0,7 % [0,2–1,6 %]
- Anteil an der Verlustzeit bei Auftreten
- 54 % [42–64 %]
- Studien / Einheiten
- 127 / 161
- Evidenzgrad
- C
Grad C: 2 bis 4 Studien oder eine Intervallbreite über 0,35.
2Wahrscheinlichkeit nach Segment
- Milchprodukte1,3 % [0,2–4,2 %]13 Studien
- Erfrischungsgetränke, abgefülltes Wasser und Säfte1,5 % [0,3–4,4 %]26 Studien
- Bier, Wein und Spirituosen1,3 % [0,2–4,4 %]11 Studien
- Backwaren und Teigwaren1,6 % [0,3–4,9 %]24 Studien
- Fleisch, Geflügel und Fisch1,3 % [0,2–4,2 %]9 Studien
- Obst- und Gemüseverarbeitung1,4 % [0,2–4,7 %]7 Studien
- Getreide- und Ölsaatenmüllerei2,1 % [0,3–6,6 %]6 Studien
- Zucker und Süßwaren1,4 % [0,2–4,6 %]9 Studien
- Snacks, Kaffee, Tee und sonstige Lebensmittel1,4 % [0,2–4,5 %]5 Studien
- Futtermittel und Heimtiernahrung1,4 % [0,2–4,6 %]7 Studien
- Lebensmittelherstellung (nicht spezifiziert oder gemischt)2,0 % [0,3–6,8 %]10 Studien
3Mechanismus, SCADA-Signatur und Gegenmaßnahme
Mechanismus
Ingenieurpraktische HinweiseThis bucket groups heterogeneous line stops that primary studies logged under generic or administrative labels rather than a defined technical failure mode, including development or trial runs, operator travel or walking time between stations, utility supply interruptions, generic equipment remarks, outright breakdowns, and incidental moisture loss. Because the original records do not isolate a single physical mechanism, the common thread is organizational or logistical rather than a specific component failure or process deviation.
So zeigt sie sich in SCADA-Daten
Ingenieurpraktische HinweiseIn SCADA/MES logs this cause appears as short-text free-form stop reasons or reason-code outliers that do not map to a standard failure or changeover taxonomy, often recorded manually with inconsistent duration patterns and no repeatable signal signature on upstream or downstream equipment. Event frequency per label is typically low and scattered across shifts rather than clustered on a specific machine state.
Gegenmaßnahme
Ingenieurpraktische HinweiseStandardize the stop-reason taxonomy and operator training so that trials, travel time, utility outages, and equipment notes are logged under distinct, well-defined codes instead of free text, and route each resulting code to the appropriate loss category for root-cause analysis. Periodically review and reclassify residual generic entries to progressively shrink this catch-all bucket.
4Quellen
- Análise da aplicação de indicadores alternativos ao Overall Equipment Effectiveness (OEE) na gestão do desempenho global de uma fábricaQuelle öffnenAnteil an der Verlustzeit: 8,70 % · laut Bericht: “Teste de P&D (e5)”
Wörtliches Zitat anzeigen
Teste de P&D (e5): 8,7% do tempo total de paradas era causado por testes realizados pela área de P&D que, embora fundamentais para o lançamento de novos produtos, também subtraem disponibilidade de tempo para produção efetiva e, portanto, precisam ser muito bem programados.
- Anteil an der Verlustzeit: 30,0 % · laut Bericht: “Quebra de equipamento”
Wörtliches Zitat anzeigen
verificou-se que as paradas do equipamento Klockner representa 30% de todos estes desperdício e que 36 % estão relacionadas com set ups e 34% são relativas a outro problemas.
- Anteil an der Verlustzeit: 16,0 % · laut Bericht: “Fornecimento de Energia”
Wörtliches Zitat anzeigen
observou-se, Figura 50, que 70% das paradas de linha estavam relacionadas a problemas no equipamento da Klockner, 16% por problemas de fornecimento de energia e 9% por problemas na máquina de injetora de tinta que faz as identificações nas bolsas plásticas.
- Propuesta para incrementar la disponibilidad de equipos a través de la implementación de Lean Manufacturing e IoT en una industria de galletas (2025)Quelle öffnenVerlustzeit: 470 min · laut Bericht: “Pruebas de Desarrollo”
Wörtliches Zitat anzeigen
Pruebas de Desarrollo 470 2.60% S/5,586.53
- Propuesta para incrementar la disponibilidad de equipos a través de la implementación de Lean Manufacturing e IoT en una industria de galletas (2025)Quelle öffnenAnteil an der Verlustzeit: 2,60 % · laut Bericht: “Pruebas de Desarrollo”
Wörtliches Zitat anzeigen
Pruebas de Desarrollo 470 2.60% S/5,586.53
- Propuesta de mejora para incrementar el rendimiento de la línea de salsas usando SMED, Kanban, Industria 4.0 y 5S en una empresa del sector alimenticio (2026)Quelle öffnenMittlere Ereignisdauer: 14,8 min · laut Bericht: “Tiempo de recorrido”
Wörtliches Zitat anzeigen
Inicialmente, se tenía un tiempo de recorrido de 14.8 min y gracias a la propuesta se alcanzó a 11 min.
- Propuesta de mejora para incrementar el rendimiento de la línea de salsas usando SMED, Kanban, Industria 4.0 y 5S en una empresa del sector alimenticio (2026)Quelle öffnenMittlere Ereignisdauer: 11,0 min · laut Bericht: “Tiempo de recorrido”
Wörtliches Zitat anzeigen
Inicialmente, se tenía un tiempo de recorrido de 14.8 min y gracias a la propuesta se alcanzó a 11 min.
- Application of TPM in line No 3 to increase production in a company that produces pasta. Lima, 2023 (2023)Quelle öffnenAnteil an der Verlustzeit: 5,00 % · laut Bericht: “pérdida de humedad”
Wörtliches Zitat anzeigen
significa un 25% de perdida y sólo es justificado el 5% por la naturaleza del proceso (pérdida de humedad)
- Implementation of TPM total productive maintenance methodology to improve productivity in a frozen food company (2023)Quelle öffnenAnteil an den Verlustereignissen: 56,0 % · laut Bericht: “OBS. EN EQUIPO”
Wörtliches Zitat anzeigen
OBS. EN EQUIPO 56%

