foratvise
Loslegen
Anlagenausfall (Störungen)

Pump failure

Anlagenausfall (Störungen)VerfügbarkeitGesamte Linie oder nicht spezifizierte Anlage

Die wissenschaftlichen Inhalte dieser Seite werden auf Englisch und Spanisch veröffentlicht; hier werden sie auf Englisch angezeigt.

Kurz gefasst

Sie tritt bei etwa 1 von 100 untersuchten Linien auf.

Wenn sie auftritt, entfällt auf sie im Mittel etwa 57 % der Verlustzeit der Linie. Berichtet von 2 der 127 Studien, die sie beobachten konnten (begrenzte Evidenz).

Was passiert

A pump (including oil/lubrication pumps supporting other equipment) loses its ability to deliver flow or pressure due to mechanical wear, seal or bearing damage, impeller blockage, loss of prime, motor or coupling failure, or electrical faults. This interrupts the fluid transfer, lubrication or hydraulic function the pump provides, stopping the dependent process or machine until repaired.

Was man dagegen tut

Apply condition-based maintenance on pumps and their lubrication circuits, including vibration monitoring, seal and bearing inspection, and scheduled oil analysis or replacement for oil pumps. Install redundant or standby pumps for critical services and configure alarms on pressure, flow and oil level to trigger early intervention before a full stop occurs.

Praktische Hinweise auf Basis ingenieurtechnischen Wissens; keine statistische Schätzung.

1Wahrscheinlichkeit und Evidenz

Gepoolt über alle Segmente. Ein breites Intervall ist ein Ergebnis: Es zeigt, wie viel die Evidenz zu wissen erlaubt.
Auftretenswahrscheinlichkeit
0,8 % [0,2–2,0 %]
Erwarteter Anteil an der Verlustzeit
0,5 % [0,1–1,2 %]
Anteil an der Verlustzeit bei Auftreten
57 % [46–67 %]
Studien / Einheiten
127 / 161
Evidenzgrad
C

Grad C: 2 bis 4 Studien oder eine Intervallbreite über 0,35.

2Wahrscheinlichkeit nach Segment

Partiell gepoolte Schätzungen für jedes Branchensegment.
  • Milchprodukte
    1,3 % [0,2–4,1 %]13 Studien
  • Erfrischungsgetränke, abgefülltes Wasser und Säfte
    0,8 % [0,1–2,4 %]26 Studien
  • Bier, Wein und Spirituosen
    0,9 % [0,1–3,2 %]11 Studien
  • Backwaren und Teigwaren
    0,8 % [0,1–2,5 %]24 Studien
  • Fleisch, Geflügel und Fisch
    0,9 % [0,1–3,0 %]9 Studien
  • Obst- und Gemüseverarbeitung
    0,9 % [0,1–3,5 %]7 Studien
  • Getreide- und Ölsaatenmüllerei
    0,9 % [0,1–3,2 %]6 Studien
  • Zucker und Süßwaren
    0,9 % [0,1–3,2 %]9 Studien
  • Snacks, Kaffee, Tee und sonstige Lebensmittel
    0,9 % [0,1–3,0 %]5 Studien
  • Futtermittel und Heimtiernahrung
    0,9 % [0,1–3,1 %]7 Studien
  • Lebensmittelherstellung (nicht spezifiziert oder gemischt)
    1,3 % [0,2–4,7 %]10 Studien

3Mechanismus, SCADA-Signatur und Gegenmaßnahme

Ingenieurpraktische Hinweise, um die Ursache zu erkennen und zu beheben; nicht Teil der statistischen Schätzung.

Mechanismus

Ingenieurpraktische Hinweise

A pump (including oil/lubrication pumps supporting other equipment) loses its ability to deliver flow or pressure due to mechanical wear, seal or bearing damage, impeller blockage, loss of prime, motor or coupling failure, or electrical faults. This interrupts the fluid transfer, lubrication or hydraulic function the pump provides, stopping the dependent process or machine until repaired.

So zeigt sie sich in SCADA-Daten

Ingenieurpraktische Hinweise

SCADA/MES shows the pump motor state dropping to off or fault while a running command is still active, with loss of discharge pressure or flow signal and possible low-level or low-pressure alarms upstream or downstream. The equipment fault log registers a pump fault code, and dependent machines show starvation or blocking states correlated in time with the pump stop.

Gegenmaßnahme

Ingenieurpraktische Hinweise

Apply condition-based maintenance on pumps and their lubrication circuits, including vibration monitoring, seal and bearing inspection, and scheduled oil analysis or replacement for oil pumps. Install redundant or standby pumps for critical services and configure alarms on pressure, flow and oil level to trigger early intervention before a full stop occurs.

4Quellen

Jeder extrahierte Datenpunkt mit Studie, Wert und wörtlichem Zitat.
  1. Anzahl der Ereignisse: 15,0 events · laut Bericht: “Pompanın çalışmaması”
    Wörtliches Zitat anzeigen
    Arıza Sayısına Göre Pareto Diyagramı 105 44 37 25 23 17 15 161 0 50 100 150 200 3 6 5 1 2 4 7 8
  2. Verlustzeit: 943 min · laut Bericht: “Pompanın çalışmaması”
    Wörtliches Zitat anzeigen
    Arıza Süresine Göre Pareto Diyagramı 4727 2495 2249 2246 1408 943 638 10768 0 2000 4000 6000 8000 10000 12000 3 5 1 6 2 7 4 8
  3. Verlustzeit: 411 min · laut Bericht: “Pump Replacements”
    Wörtliches Zitat anzeigen
    411 Pump Replacements
  4. Anzahl der Ereignisse: 12,0 occurrences · laut Bericht: “electric pump downtime”
    Wörtliches Zitat anzeigen
    a 40% decrease in electric pump downtime (from 20 to 12 occurrences)
  5. Anzahl der Ereignisse: 20,0 occurrences · laut Bericht: “electric pump downtime”
    Wörtliches Zitat anzeigen
    a 40% decrease in electric pump downtime (from 20 to 12 occurrences)
  6. Verlustzeit: 1,00 h · laut Bericht: “Pompa oli”
    Wörtliches Zitat anzeigen
    Pompa oli | Rp520.000 | Rp350.000 | 3 Jam 30 Menit | 1 Jam 0 Menit