Fallen Product Requiring Cleanup
Die wissenschaftlichen Inhalte dieser Seite werden auf Englisch und Spanisch veröffentlicht; hier werden sie auf Englisch angezeigt.
Kurz gefasst
Sie tritt bei etwa 1 von 100 untersuchten Linien auf.
Wenn sie auftritt, entfällt auf sie im Mittel etwa 53 % der Verlustzeit der Linie. Berichtet von 1 der 112 Studien, die sie beobachten konnten (spärliche Evidenz).
Was passiert
Containers, packs or product units lose stability on the conveyor or at a transfer point on the packaging machine and fall off the line, often due to misalignment, uneven surfaces, vibration or an upstream jam. The operator must stop the equipment briefly to retrieve the fallen items and wipe or clean the area before restarting, since spilled product can contaminate the line or cause further jams.
Was man dagegen tut
Add guide rails, side guards or stabilizing guides at transfer points and conveyor curves to prevent product from tipping or falling, and correct conveyor alignment and surface leveling. Install sensors to detect unstable product flow early and trigger a controlled slow-down, and establish a standard quick-clean procedure to minimize the time lost when a fall does occur.
Praktische Hinweise auf Basis ingenieurtechnischen Wissens; keine statistische Schätzung.
1Wahrscheinlichkeit und Evidenz
- Auftretenswahrscheinlichkeit
- 0,5 % [0,1–1,5 %]
- Erwarteter Anteil an der Verlustzeit
- 0,3 % [0,1–0,8 %]
- Anteil an der Verlustzeit bei Auftreten
- 53 % [41–65 %]
- Studien / Einheiten
- 112 / 155
- Evidenzgrad
- D
Grad D: 0 oder 1 Studie; die Schätzung beruht auf partiellem Pooling und Priori-Verteilungen, und das breite Intervall ist das Ergebnis.
2Wahrscheinlichkeit nach Segment
- Milchprodukte0,6 % [0,1–2,3 %]14 Studien
- Erfrischungsgetränke, abgefülltes Wasser und Säfte0,5 % [0,1–1,8 %]33 Studien
- Bier, Wein und Spirituosen0,6 % [0,1–2,2 %]14 Studien
- Backwaren und Teigwaren0,6 % [0,1–2,3 %]6 Studien
- Fleisch, Geflügel und Fisch0,6 % [0,1–2,4 %]6 Studien
- Obst- und Gemüseverarbeitung0,6 % [0,1–2,4 %]4 Studien
- Getreide- und Ölsaatenmüllerei0,6 % [0,1–2,3 %]4 Studien
- Zucker und Süßwaren0,6 % [0,1–2,5 %]4 Studien
- Snacks, Kaffee, Tee und sonstige Lebensmittel0,6 % [0,1–2,0 %]8 Studien
- Futtermittel und Heimtiernahrung0,6 % [0,1–2,4 %]5 Studien
- Lebensmittelherstellung (nicht spezifiziert oder gemischt)0,9 % [0,1–3,1 %]14 Studien
3Mechanismus, SCADA-Signatur und Gegenmaßnahme
Mechanismus
Ingenieurpraktische HinweiseContainers, packs or product units lose stability on the conveyor or at a transfer point on the packaging machine and fall off the line, often due to misalignment, uneven surfaces, vibration or an upstream jam. The operator must stop the equipment briefly to retrieve the fallen items and wipe or clean the area before restarting, since spilled product can contaminate the line or cause further jams.
So zeigt sie sich in SCADA-Daten
Ingenieurpraktische HinweiseAppears as frequent short stop events in the minor-stop counter with manual-clear or operator-intervention flags rather than maintenance work orders; line speed drops momentarily and downstream stations show starvation while upstream units show blocking during the stop. Stop durations cluster below the maintenance threshold and no fault code tied to a mechanical failure is raised.
Gegenmaßnahme
Ingenieurpraktische HinweiseAdd guide rails, side guards or stabilizing guides at transfer points and conveyor curves to prevent product from tipping or falling, and correct conveyor alignment and surface leveling. Install sensors to detect unstable product flow early and trigger a controlled slow-down, and establish a standard quick-clean procedure to minimize the time lost when a fall does occur.
4Quellen
- Anteil an der Verlustzeit: 7,94 % · laut Bericht: “Fallen product and Cleaning”
Wörtliches Zitat anzeigen
Fallen product and Cleaning 7.94% 10.09% 31.47%
- Anteil an der Verlustzeit: 31,5 % · laut Bericht: “Fallen product and Cleaning”
Wörtliches Zitat anzeigen
Fallen product and Cleaning 7.94% 10.09% 31.47%

