foratvise
Loslegen
Rüsten und Einstellen

Manual cleaning of mixing equipment during changeover

Rüsten und EinstellenVerfügbarkeitMischen und Vermengen

Die wissenschaftlichen Inhalte dieser Seite werden auf Englisch und Spanisch veröffentlicht; hier werden sie auf Englisch angezeigt.

Kurz gefasst

Sie tritt bei etwa 1 von 100 untersuchten Linien auf.

Wenn sie auftritt, entfällt auf sie im Mittel etwa 57 % der Verlustzeit der Linie. Berichtet von 2 der 31 Studien, die sie beobachten konnten (begrenzte Evidenz).

Was passiert

Between production runs, operators must manually clean residue from different levels or sections of the mixer using tools such as brooms, vacuum cleaners, compressed air lances or torches, because the design does not allow automated or CIP-only cleaning of these areas. This hands-on task extends the time between the last good unit of one run and the first good unit of the next, as it requires access, tool retrieval and physical scrubbing before the mixer can be restarted.

Was man dagegen tut

Redesign access points and internal surfaces of the mixer to allow automated or semi-automated cleaning, such as fixed spray nozzles or CIP circuits, for areas currently cleaned by hand, and standardize cleaning procedures with dedicated tool kits staged at the equipment to reduce search and setup time. Where manual cleaning cannot be eliminated, use parallel tasking or quick-release panels to shorten the critical path of the changeover.

Praktische Hinweise auf Basis ingenieurtechnischen Wissens; keine statistische Schätzung.

1Wahrscheinlichkeit und Evidenz

Gepoolt über alle Segmente. Ein breites Intervall ist ein Ergebnis: Es zeigt, wie viel die Evidenz zu wissen erlaubt.
Auftretenswahrscheinlichkeit
1,3 % [0,2–3,7 %]
Erwarteter Anteil an der Verlustzeit
0,7 % [0,1–2,2 %]
Anteil an der Verlustzeit bei Auftreten
57 % [44–67 %]
Studien / Einheiten
31 / 40
Evidenzgrad
C

Grad C: 2 bis 4 Studien oder eine Intervallbreite über 0,35.

2Wahrscheinlichkeit nach Segment

Partiell gepoolte Schätzungen für jedes Branchensegment.
  • Milchprodukte
    1,4 % [0,2–5,1 %]6 Studien
  • Erfrischungsgetränke, abgefülltes Wasser und Säfte
    1,5 % [0,2–5,4 %]2 Studien
  • Bier, Wein und Spirituosen
    1,6 % [0,1–5,9 %]0 Studien
  • Backwaren und Teigwaren
    2,1 % [0,2–7,2 %]2 Studien
  • Fleisch, Geflügel und Fisch
    1,5 % [0,2–5,8 %]1 Studie
  • Obst- und Gemüseverarbeitung
    1,5 % [0,2–6,2 %]2 Studien
  • Getreide- und Ölsaatenmüllerei
    1,6 % [0,1–6,0 %]0 Studien
  • Zucker und Süßwaren
    1,5 % [0,1–5,8 %]3 Studien
  • Snacks, Kaffee, Tee und sonstige Lebensmittel
    2,1 % [0,2–7,5 %]3 Studien
  • Futtermittel und Heimtiernahrung
    1,4 % [0,1–5,0 %]5 Studien
  • Lebensmittelherstellung (nicht spezifiziert oder gemischt)
    1,5 % [0,1–5,5 %]7 Studien

3Mechanismus, SCADA-Signatur und Gegenmaßnahme

Ingenieurpraktische Hinweise, um die Ursache zu erkennen und zu beheben; nicht Teil der statistischen Schätzung.

Mechanismus

Ingenieurpraktische Hinweise

Between production runs, operators must manually clean residue from different levels or sections of the mixer using tools such as brooms, vacuum cleaners, compressed air lances or torches, because the design does not allow automated or CIP-only cleaning of these areas. This hands-on task extends the time between the last good unit of one run and the first good unit of the next, as it requires access, tool retrieval and physical scrubbing before the mixer can be restarted.

So zeigt sie sich in SCADA-Daten

Ingenieurpraktische Hinweise

The mixer state log shows an extended changeover or stopped state with no process variable movement, often preceded by a product or recipe change event; auxiliary equipment such as agitators and discharge valves remain idle for the duration. No fault or alarm is typically logged, since the stoppage is procedural rather than a failure, and the event is usually tagged manually as cleaning or changeover time in the MES if recorded at all.

Gegenmaßnahme

Ingenieurpraktische Hinweise

Redesign access points and internal surfaces of the mixer to allow automated or semi-automated cleaning, such as fixed spray nozzles or CIP circuits, for areas currently cleaned by hand, and standardize cleaning procedures with dedicated tool kits staged at the equipment to reduce search and setup time. Where manual cleaning cannot be eliminated, use parallel tasking or quick-release panels to shorten the critical path of the changeover.

4Quellen

Jeder extrahierte Datenpunkt mit Studie, Wert und wörtlichem Zitat.
  1. Verlustzeit: 188 min · laut Bericht: “Flavour mixer cleaning and setup”
    Wörtliches Zitat anzeigen
    Flavour mixer cleaning and setup 188 minutes
  2. Verlustzeit: 135 min · laut Bericht: “Oil drum cleaning and setup”
    Wörtliches Zitat anzeigen
    Oil drum cleaning and setup 135 minutes
  3. Anteil an der Verlustzeit: 19,0 % · laut Bericht: “mixer washing”
    Wörtliches Zitat anzeigen
    the total single washing time was 5 hours 3 minutes on average, which accounted for about 19% of the total retooling of the production line
  4. Mittlere Ereignisdauer: 0,220 min · laut Bericht: “Bring torch for cleaning of 2nd level”
    Wörtliches Zitat anzeigen
    Bring torch for cleaning of 2nd level Operator 2 DRY Operator 2 DRY External External 0.22 0.25
  5. Mittlere Ereignisdauer: 4,50 min · laut Bericht: “Clean 3rd level with broom and vacuum”
    Wörtliches Zitat anzeigen
    Clean 3rd level with broom and vacuum Operator 2 DRY Operator 2 DRY Internal Internal 4.50 2.60
  6. Mittlere Ereignisdauer: 16,0 min · laut Bericht: “Clean mixer at 2nd level with broom and air”
    Wörtliches Zitat anzeigen
    Clean mixer at 2nd level with broom and air Operator 1 DRY Operator 1 DRY Internal Internal 16.00 7.80
  7. Mittlere Ereignisdauer: 0,250 min · laut Bericht: “Bring torch for cleaning of 2nd level”
    Wörtliches Zitat anzeigen
    Bring torch for cleaning of 2nd level Operator 2 DRY Operator 2 DRY External External 0.22 0.25
  8. Mittlere Ereignisdauer: 2,60 min · laut Bericht: “Clean 3rd level with broom and vacuum”
    Wörtliches Zitat anzeigen
    Clean 3rd level with broom and vacuum Operator 2 DRY Operator 2 DRY Internal Internal 4.50 2.60
  9. Mittlere Ereignisdauer: 7,80 min · laut Bericht: “Clean mixer at 2nd level with broom and air”
    Wörtliches Zitat anzeigen
    Clean mixer at 2nd level with broom and air Operator 1 DRY Operator 1 DRY Internal Internal 16.00 7.80