Capping head mechanical failure
In short
It appears in about 1 of every 100 lines studied.
When it appears, it takes on average about 58 % of the line's lost time. Reported by 1 of the 82 studies that could observe it (sparse evidence).
What happens
A mechanical component within the capping/closing head assembly (such as the torque or cap-setting mechanism) wears, breaks or seizes, so the head can no longer apply or release caps correctly. This forces the capper to stop until the damaged part is repaired or replaced.
What is done about it
Apply preventive maintenance with scheduled inspection, lubrication and replacement of wear parts in the capping head assembly, and verify torque/alignment calibration after any intervention. Keep critical spare mechanical parts available to minimize repair time when a failure occurs.
Practical guidance written from engineering knowledge; it is not a statistical estimate.
1Probability and evidence
- Probability of presence
- 0.7% [0.1–1.9%]
- Expected share of lost time
- 0.4% [0.1–1.1%]
- Share of lost time when present
- 58% [47–69%]
- Studies / units
- 82 / 109
- Evidence grade
- D
Grade D: 0 or 1 study; the estimate is driven by partial pooling and priors, and the wide interval is the result.
2Probability by segment
- Dairy products0.8% [0.1–2.8%]11 studies
- Soft drinks, bottled water and juices0.9% [0.1–3.0%]26 studies
- Brewing, wine and spirits0.8% [0.1–2.8%]11 studies
- Bakery and pasta0.8% [0.1–3.2%]0 studies
- Meat, poultry and seafood0.8% [0.1–2.7%]7 studies
- Fruit and vegetable processing0.8% [0.1–3.0%]4 studies
- Grain and oilseed milling0.8% [0.1–3.0%]3 studies
- Sugar and confectionery0.8% [0.1–3.1%]3 studies
- Snacks, coffee, tea and other foods0.8% [0.1–3.0%]4 studies
- Animal feed and pet food0.8% [0.1–2.9%]4 studies
- Food manufacturing (unspecified or mixed)0.8% [0.1–2.8%]9 studies
3Mechanism, SCADA signature and countermeasure
Mechanism
Engineering guidanceA mechanical component within the capping/closing head assembly (such as the torque or cap-setting mechanism) wears, breaks or seizes, so the head can no longer apply or release caps correctly. This forces the capper to stop until the damaged part is repaired or replaced.
How it looks in SCADA data
Engineering guidanceThe capper logs a mechanical fault or stop-state with a maintenance-type alarm code, often preceded by a trend of irregular torque or position feedback on the affected head. Downstream filling and upstream conveying stations show blocking or starvation while the machine remains in fault state until an operator or technician resets it after intervention.
Countermeasure
Engineering guidanceApply preventive maintenance with scheduled inspection, lubrication and replacement of wear parts in the capping head assembly, and verify torque/alignment calibration after any intervention. Keep critical spare mechanical parts available to minimize repair time when a failure occurs.
4Sources
- Share of loss events: 82.0 % · as reported: “Falha no conjunto do Regusetter (problemas mecânicos)”
Show verbatim quote
analisando-se os registros verificou-se que os problemas mecânicos existentes no regusseter, representava 82 % das falhas, validando assim como uma causa-raiz.

