foratvise
Get Started
Setup and adjustments

Detergent/disinfectant solution preparation

Setup and adjustmentsAvailabilityCleaning in place (CIP) and sanitation

In short

It appears in fewer than 1 of every 100 lines studied.

When it appears, it takes on average about 56 % of the line's lost time. Reported by 1 of the 129 studies that could observe it (sparse evidence).

What happens

Before a cleaning or sanitation cycle can start, operators must dose, dilute and heat the detergent or disinfectant to the concentration and temperature specified by the cleaning procedure, which consumes line time without any product being made. This preparation step is part of the changeover/sanitation window because the line or equipment cannot resume production until the solution is ready and the cleaning cycle has run.

What is done about it

Pre-batch and store ready-to-use detergent/disinfectant solutions, or automate dosing and dilution with inline mixing and concentration sensors so the solution reaches setpoint in parallel with other changeover tasks rather than in series. Standardizing recipes and using automated CIP skids with recipe-driven dosing reduces variability and shortens the preparation window.

Practical guidance written from engineering knowledge; it is not a statistical estimate.

1Probability and evidence

Pooled over all segments. A wide interval is a result: it states how much the evidence allows us to know.
Probability of presence
0.5% [0.1–1.4%]
Expected share of lost time
0.3% [0.1–0.8%]
Share of lost time when present
56% [44–67%]
Studies / units
129 / 163
Evidence grade
D

Grade D: 0 or 1 study; the estimate is driven by partial pooling and priors, and the wide interval is the result.

2Probability by segment

Partially pooled estimates for each industry segment.
  • Dairy products
    0.6% [0.1–2.0%]13 studies
  • Soft drinks, bottled water and juices
    0.5% [0.1–1.7%]27 studies
  • Brewing, wine and spirits
    0.6% [0.1–2.2%]11 studies
  • Bakery and pasta
    0.5% [0.1–1.8%]24 studies
  • Meat, poultry and seafood
    0.6% [0.1–2.1%]9 studies
  • Fruit and vegetable processing
    0.6% [0.1–2.1%]7 studies
  • Grain and oilseed milling
    0.6% [0.1–2.1%]6 studies
  • Sugar and confectionery
    0.6% [0.1–2.2%]9 studies
  • Snacks, coffee, tea and other foods
    0.6% [0.1–2.2%]5 studies
  • Animal feed and pet food
    0.8% [0.1–3.0%]7 studies
  • Food manufacturing (unspecified or mixed)
    0.6% [0.1–2.2%]11 studies

3Mechanism, SCADA signature and countermeasure

Engineering guidance that helps recognise and address the cause; it is not part of the statistical estimate.

Mechanism

Engineering guidance

Before a cleaning or sanitation cycle can start, operators must dose, dilute and heat the detergent or disinfectant to the concentration and temperature specified by the cleaning procedure, which consumes line time without any product being made. This preparation step is part of the changeover/sanitation window because the line or equipment cannot resume production until the solution is ready and the cleaning cycle has run.

How it looks in SCADA data

Engineering guidance

MES/SCADA logs show the line or CIP skid in a dedicated 'cleaning preparation' or 'setup' state preceding the actual CIP wash-phase state, with tank level and conductivity or concentration sensors ramping up toward setpoint before the cleaning cycle timer starts. Downstream equipment shows starvation (idle, no product flow) for the duration of this preparation state, and the event recurs at a regular cadence tied to changeover or shift-start events.

Countermeasure

Engineering guidance

Pre-batch and store ready-to-use detergent/disinfectant solutions, or automate dosing and dilution with inline mixing and concentration sensors so the solution reaches setpoint in parallel with other changeover tasks rather than in series. Standardizing recipes and using automated CIP skids with recipe-driven dosing reduces variability and shortens the preparation window.

4Sources

Every extracted datum with its study, value and verbatim quote.
  1. Mean event duration: 2.09 min · as reported: “Prepare detergent/disinfectant solution”
    Show verbatim quote
    Prepare detergent/disinfectant solution 2.09 Internal External
  2. Lost time: 2.09 min · as reported: “Prepare detergent/disinfectant solution”
    Show verbatim quote
    Prepare detergent/disinfectant solution 2.09