foratvise
Get Started
Process defects (scrap and rework)

Sucrose Loss to Acid Hydrolysis in Evaporation

Process defects (scrap and rework)QualityEvaporation

In short

It appears in about 2 of every 100 lines studied.

When it appears, it takes on average about 49 % of the line's lost time. Reported by 5 of the 29 studies that could observe it (limited evidence).

What happens

In the evaporator station, sucrose present in the juice or syrup undergoes acid-catalyzed hydrolysis into reducing sugars when pH is below the optimal range and the material is exposed to elevated temperature for prolonged residence time in the effects. This chemical degradation consumes recoverable sucrose without interrupting equipment operation, so it is recorded as a first-pass yield or quality loss rather than a stoppage; it is often compounded by mechanical breakdowns or reduced throughput that extend the time the product spends under hydrolysis-prone conditions.

What is done about it

Control and stabilize feed and in-process pH within the target range through alkali dosing ahead of and within the evaporation stage, and minimize residence time and local overheating by maintaining correct circulation, vacuum and temperature profiles per effect. Continuously monitor pH, Brix and purity with automated dosing correction, and address underlying mechanical breakdowns or speed losses promptly so product does not linger under hydrolysis-prone conditions.

Practical guidance written from engineering knowledge; it is not a statistical estimate.

1Probability and evidence

Pooled over all segments. A wide interval is a result: it states how much the evidence allows us to know.
Probability of presence
2.5% [0.5–6.7%]
Expected share of lost time
1.2% [0.2–3.4%]
Share of lost time when present
49% [37–61%]
Studies / units
29 / 34
Evidence grade
C

Grade C: 2 to 4 studies, or an interval wider than 0.35.

2Probability by segment

Partially pooled estimates for each industry segment.
  • Dairy products
    2.7% [0.3–9.5%]5 studies
  • Soft drinks, bottled water and juices
    2.9% [0.3–10.8%]1 study
  • Brewing, wine and spirits
    2.9% [0.3–11.2%]0 studies
  • Bakery and pasta
    3.0% [0.3–11.1%]0 studies
  • Meat, poultry and seafood
    2.9% [0.3–10.9%]0 studies
  • Fruit and vegetable processing
    2.8% [0.3–10.1%]2 studies
  • Grain and oilseed milling
    3.0% [0.3–10.3%]0 studies
  • Sugar and confectionery
    5.3% [0.7–16.7%]6 studies
  • Snacks, coffee, tea and other foods
    2.7% [0.3–10.0%]3 studies
  • Animal feed and pet food
    2.7% [0.3–9.9%]4 studies
  • Food manufacturing (unspecified or mixed)
    3.8% [0.5–12.7%]8 studies

3Mechanism, SCADA signature and countermeasure

Engineering guidance that helps recognise and address the cause; it is not part of the statistical estimate.

Mechanism

Engineering guidance

In the evaporator station, sucrose present in the juice or syrup undergoes acid-catalyzed hydrolysis into reducing sugars when pH is below the optimal range and the material is exposed to elevated temperature for prolonged residence time in the effects. This chemical degradation consumes recoverable sucrose without interrupting equipment operation, so it is recorded as a first-pass yield or quality loss rather than a stoppage; it is often compounded by mechanical breakdowns or reduced throughput that extend the time the product spends under hydrolysis-prone conditions.

How it looks in SCADA data

Engineering guidance

Evaporator run-state logs typically show the equipment operating normally or intermittently in breakdown/reduced-speed states, while laboratory or process-quality trends reveal falling juice pH, rising reducing-sugar content and declining sucrose purity or recovery across effects. Mass-balance and yield reports at the evaporator station show a gap between theoretical and actual sucrose output that correlates with low pH excursions, extended batch or effect residence time, and periods of equipment breakdown or slow running rather than with any single alarm.

Countermeasure

Engineering guidance

Control and stabilize feed and in-process pH within the target range through alkali dosing ahead of and within the evaporation stage, and minimize residence time and local overheating by maintaining correct circulation, vacuum and temperature profiles per effect. Continuously monitor pH, Brix and purity with automated dosing correction, and address underlying mechanical breakdowns or speed losses promptly so product does not linger under hydrolysis-prone conditions.

4Sources

Every extracted datum with its study, value and verbatim quote.
  1. Defect rate: 0.550 % · as reported: “sucrose loss to acid hydrolysis”
    Show verbatim quote
    A target FES pH of 5.9 caused a season average sucrose loss of 0.55% equivalent to 1.52 lbs sucrose lost/ton of cane and a minimum USD 390,400 loss in profits.
  2. Defect rate: 0.360 % · as reported: “sucrose loss to acid hydrolysis”
    Show verbatim quote
    In contrast, a target FES pH of 6.5 reduced this sucrose loss to 0.36% and 1.01 lbs sucrose lost/ton of cane and saved the factory a minimum of USD 131,100.
  3. Defect rate: 1.42 % · as reported: “total sucrose losses to acid hydrolysis”
    Show verbatim quote
    A wide range of 0.21–1.42% total sucrose losses to acid hydrolysis were measured across the station, which were affected by seasonal changes in clarified juice quality.
  4. Defect rate: 0.210 % · as reported: “total sucrose losses to acid hydrolysis”
    Show verbatim quote
    A wide range of 0.21–1.42% total sucrose losses to acid hydrolysis were measured across the station, which were affected by seasonal changes in clarified juice quality.
  5. Share of lost time: 98.0 % · as reported: “sucrose losses to acid hydrolysis”
    Show verbatim quote
    Losses in the pre-evaporators were up to 98% of the total station losses in early season but decreased in midseason
  6. Number of events: 44.0 events · as reported: “Kerusakan mesin”
    Show verbatim quote
    Evaporator 44 24,3
  7. Share of loss events: 24.3 % · as reported: “Kerusakan mesin”
    Show verbatim quote
    Evaporator 44 24,3
  8. Share of lost time: 4.70 % · as reported: “breakdown losses”
    Show verbatim quote
    Rendahnya efektifitas mesin evaporator diakibatkan tingginya kontribusi yang diberikan oleh 2 faktor six big losses yaitu tingginya nilai breakdown losses sebesar 4,7% dan reduced speed losses sebesar 2,5%.
  9. Share of lost time: 2.50 % · as reported: “reduced speed losses”
    Show verbatim quote
    Rendahnya efektifitas mesin evaporator diakibatkan tingginya kontribusi yang diberikan oleh 2 faktor six big losses yaitu tingginya nilai breakdown losses sebesar 4,7% dan reduced speed losses sebesar 2,5%.
  10. Share of planned time: 4.70 % · as reported: “breakdown losses”
    Show verbatim quote
    tingginya nilai breakdown losses sebesar 4,7%
  11. Share of planned time: 2.50 % · as reported: “reduced speed losses”
    Show verbatim quote
    reduced speed losses sebesar 2,5%