Component wear and tear
In short
It appears in fewer than 1 of every 100 lines studied.
When it appears, it takes on average about 58 % of the line's lost time. Reported by 0 of the 127 studies that could observe it (sparse evidence).
What happens
Mechanical parts such as bearings, seals, belts, chains and gaskets progressively lose material or elasticity through repeated friction, cyclic loading and contact with product or cleaning agents. Once the accumulated degradation passes a tolerance limit, the component can no longer perform its function and the equipment stops or fails.
What is done about it
Implement condition-based or time-based preventive maintenance with periodic inspection, lubrication and replacement of wear parts before they reach failure, supported by trending of condition-monitoring signals to anticipate degradation.
Practical guidance written from engineering knowledge; it is not a statistical estimate.
1Probability and evidence
- Probability of presence
- 0.4% [0.1–1.1%]
- Expected share of lost time
- 0.2% [0.0–0.6%]
- Share of lost time when present
- 58% [46–68%]
- Studies / units
- 127 / 161
- Evidence grade
- D
Grade D: 0 or 1 study; the estimate is driven by partial pooling and priors, and the wide interval is the result.
2Probability by segment
- Dairy products0.4% [0.0–1.6%]13 studies
- Soft drinks, bottled water and juices0.4% [0.0–1.5%]26 studies
- Brewing, wine and spirits0.4% [0.0–1.6%]11 studies
- Bakery and pasta0.4% [0.0–1.6%]24 studies
- Meat, poultry and seafood0.4% [0.0–1.7%]9 studies
- Fruit and vegetable processing0.5% [0.0–1.8%]7 studies
- Grain and oilseed milling0.5% [0.0–1.8%]6 studies
- Sugar and confectionery0.4% [0.0–1.8%]9 studies
- Snacks, coffee, tea and other foods0.4% [0.0–1.7%]5 studies
- Animal feed and pet food0.4% [0.0–1.7%]7 studies
- Food manufacturing (unspecified or mixed)0.4% [0.0–1.7%]10 studies
3Mechanism, SCADA signature and countermeasure
Mechanism
Engineering guidanceMechanical parts such as bearings, seals, belts, chains and gaskets progressively lose material or elasticity through repeated friction, cyclic loading and contact with product or cleaning agents. Once the accumulated degradation passes a tolerance limit, the component can no longer perform its function and the equipment stops or fails.
How it looks in SCADA data
Engineering guidanceSCADA/MES data show a gradual drift in vibration, current, torque or temperature trends on the affected asset before an unplanned stop, together with increasing frequency of short unplanned downtime alarms on the same machine over time. The stop event is typically logged as an unplanned mechanical or electrical fault with no preceding operator-triggered state change.
Countermeasure
Engineering guidanceImplement condition-based or time-based preventive maintenance with periodic inspection, lubrication and replacement of wear parts before they reach failure, supported by trending of condition-monitoring signals to anticipate degradation.
4Sources
- Penerapan Total Productive Maintenance (TPM) Pada Pabrik Gula Rafinasi di Indonesia (Studi Kasus: PT. XYZ) (2019)Open sourceShare of loss events: 80.4 % · as reported: “normal wear and tear”
Show verbatim quote
Kerusakan mesin 80,44% terjadi karena adanya kerusakan komponen yang masuk kategori normal wear and tear atau aus karena umur pakainya.

