foratvise
Get Started
not classifiable

Unspecified bottling line cycle time loss

In short

It appears in fewer than 1 of every 100 lines studied.

When it appears, it takes on average about 57 % of the line's lost time. Reported by 0 of the 127 studies that could observe it (sparse evidence).

What happens

The source label only references a change or gap in overall bottling cycle time without identifying the underlying equipment, changeover, stoppage or quality event that produced it, so the physical or organisational mechanism cannot be determined from the report.

What is done about it

Improve data capture by tagging stoppage and slow-running events at the machine level with standardized reason codes, so that generic cycle time gaps can be reclassified into specific equipment, changeover, or quality causes for targeted improvement.

Practical guidance written from engineering knowledge; it is not a statistical estimate.

1Probability and evidence

Pooled over all segments. A wide interval is a result: it states how much the evidence allows us to know.
Probability of presence
0.4% [0.1–1.1%]
Expected share of lost time
0.2% [0.0–0.6%]
Share of lost time when present
57% [45–67%]
Studies / units
127 / 161
Evidence grade
D

Grade D: 0 or 1 study; the estimate is driven by partial pooling and priors, and the wide interval is the result.

2Probability by segment

Partially pooled estimates for each industry segment.
  • Dairy products
    0.4% [0.0–1.7%]13 studies
  • Soft drinks, bottled water and juices
    0.4% [0.0–1.4%]26 studies
  • Brewing, wine and spirits
    0.4% [0.0–1.6%]11 studies
  • Bakery and pasta
    0.4% [0.0–1.6%]24 studies
  • Meat, poultry and seafood
    0.4% [0.0–1.7%]9 studies
  • Fruit and vegetable processing
    0.4% [0.0–1.6%]7 studies
  • Grain and oilseed milling
    0.4% [0.0–1.8%]6 studies
  • Sugar and confectionery
    0.4% [0.0–1.6%]9 studies
  • Snacks, coffee, tea and other foods
    0.4% [0.0–1.7%]5 studies
  • Animal feed and pet food
    0.4% [0.0–1.7%]7 studies
  • Food manufacturing (unspecified or mixed)
    0.5% [0.0–1.8%]10 studies

3Mechanism, SCADA signature and countermeasure

Engineering guidance that helps recognise and address the cause; it is not part of the statistical estimate.

Mechanism

Engineering guidance

The source label only references a change or gap in overall bottling cycle time without identifying the underlying equipment, changeover, stoppage or quality event that produced it, so the physical or organisational mechanism cannot be determined from the report.

How it looks in SCADA data

Engineering guidance

In SCADA/MES data this shows up only as a generic deviation between actual and target cycle time or throughput at the line level, without a specific machine state, alarm, or fault code that can be attributed to a single asset or cause.

Countermeasure

Engineering guidance

Improve data capture by tagging stoppage and slow-running events at the machine level with standardized reason codes, so that generic cycle time gaps can be reclassified into specific equipment, changeover, or quality causes for targeted improvement.

4Sources

Every extracted datum with its study, value and verbatim quote.
  1. Lost time: 2.51 hours · as reported: “optimized bottling process cycle time”
    Show verbatim quote
    the cycle time decreased from 5.10 hours to 2.51 hours, representing a 50.78% reduction in time.